Intended Use - Becker Centronic VarioControl VC260 Instructions De Montage Et D'utilisation

The radio receiver described in these instructions may only be used for the op-
eration of roller shutter systems with fixed stops in the upper limit position and
anti-lifting devices fitted. This control unit is only compatible with our Ø35 mm
DC tubular drives. The connection of external devices must be carried out in
consultation with specialist retailers.
• Please note that radio-controlled systems may not be used in areas with a
high risk of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and systems
in which malfunctions in the transmitter or receiver would not pose any risk
to persons, animals or property, or which contain safety devices to elimin-
ate such risks.
• The operator is not protected from interference from other telecommunic-
ations systems and terminal equipment (e.g. even from radio-controlled
systems which are properly operated in the same frequency range).
• Only connect radio receivers to devices and systems approved by the
manufacturer.
•
Ensure that the control unit is not installed or operated
close to metal surfaces or magnetic fields.
• Radio-controlled systems transmitting on the same fre-
quency may cause reception interference.
• Note that the range of the radio signal is limited by legis-
lation as well as by design.

Intended use

23 - en