Intermediate Positions I + Ii - Becker Centronic VarioControl VC260 Instructions De Montage Et D'utilisation

Intermediate positions I + II

The intermediate positions I + II are freely selectable posi-
tions for the shading solution between the two limit posi-
tions. Each travel button can be assigned one intermediate
position. Both limit positions must be set before an interme-
diate position is set.
When both or individual limit positions are deleted, both in-
termediate positions are deleted as well.
Setting the desired intermediate position
Travel the shading solution from the corresponding limit position to the de-
sired intermediate position.
Now press the STOP button and, within 3 seconds, also press the travel button
of the corresponding limit position and hold the two buttons down.
▻ The shading solution shifts to confirm.
► The intermediate position is now saved.
Travelling to the desired intermediate position
The shading solution must run to the intermediate position
from the corresponding limit position.
Press the travel button for the desired intermediate position twice within one
second.
► The shading solution runs to the intermediate position assigned to the
travel button.
Deleting the desired intermediate position
Open/close the shading solution to the intermediate position to be deleted.
Now press the STOP button and, within 3 seconds, also press the travel button
assigned to the intermediate position and hold the two buttons down.
▻ The shading solution shifts to confirm.
► The intermediate position is now deleted.
32 - en