Programming The Intermediate Positions I + Ii - Becker Centronic VarioControl VC520 Notice De Montage Et D'utilisation

Programming the intermediate positions I +
Intermediate position I
The intermediate position I is any shading solution position of
your choosing, situated between the upper and lower limit
positions. Both limit positions must be set before the inter-
mediate position I is set.
The intermediate position I is approached from the upper
limit position.
Setting the intermediate position I
Move the shading solution from the upper limit position to the desired interme-
diate position I.
Press the STOP button and, within 3 seconds, also press the DOWN button
and hold the two buttons down.
▻ The receiver confirms.
► The intermediate position I is now saved.
Checking the intermediate position I
Press the DOWN button twice within one second.
► The shading solution runs to the intermediate position I.
Deleting the intermediate position I
Move the shading solution to the intermediate position I.
Press the STOP button and, within 3 seconds, also press the DOWN button
and hold the two buttons down.
▻ The receiver confirms.
► The intermediate position I is now deleted.
II
29 - en