Programming The Transmitter - Becker Centronic VarioControl VC520 Notice De Montage Et D'utilisation

Programming the transmitter

Caution
• Risk of injury due to electric shock.
• Connection may only be performed by a qualified electri-
cian!
•
The device only offers back-of-hand protection, not
touch protection.
•
Only operate the programming button with an insulated
tool.
•
Always take into account the device switching current.
Putting the radio receiver into programming mode
a) Putting the radio receiver into programming mode by switching on
the power
Switch on the power.
► The radio receiver remains ready for programming for 3 minutes.
b) Putting the radio receiver into programming mode with the program-
ming button
Press the programming button for 3 seconds.
► The radio receiver remains ready for programming for 3 minutes.
Programming the master transmitter
The master transmitter refers to the very first transmitter
programmed in a receiver. In contrast to subsequently pro-
grammed transmitters, the master transmitter enables,
among other things, the setting of limit positions (for drives
with integrated radio receiver) and the programming or de-
leting of further transmitters. Any transmitter that has separ-
ate UP, STOP, DOWN buttons and a programming button can
be a master transmitter.
If a transmitter is already programmed in the receiver, press
the programming button of the transmitter for 10 seconds.
26 - en