Programming The Remote Control - Becker VarioControl VC420-II Notice De Montage Et D'utilisation

Programming the remote control
Caution
• Risk of injury by electric shock.
• Must be installed by an authorised electrician!
• Only the back of the hand is protected by the device. No protection
against accidental contact!
• The programming button must be operated with an insulated tool.
• The switched current of the device must be observed at all times.
Setting the VC420-II to programming mode
a) Set the VC420-II to programming mode by switching on the power sup-
ply
Switch on the power supply.
The VC420II will remain in programming mode for 3 minutes.
b) Set the VC420-II to programming mode using the programming button
Press and hold the programming button for 3 seconds.
The VC420II will remain in programming mode for 3 minutes.
Programming master transmitter
Note
The master transmitter is the very first transmitter programmed on a
receiver. In contrast to subsequently programmed transmitters, the
master transmitter enables, among other things, the setting of limit
positions (for drives with integr. radio receiver) and the programming
or deleting of further transmitters.Any transmitter which has a separa-
te UP, STOP, DOWN button and a programming button can be a master
transmitter.
If a transmitter is already programmed on the receiver, press the
programming button of the transmitter for 10 seconds.
Press the programming button of the transmitter for 3 seconds when it is ready
to programme.
The system will confirm the programme setting with a 'nod', i.e. the shutter/
awning/blind moves a few centimetres in one direction and then reverses the
same distance.
This confirmation is hereafter referred to as 'nodding'.
The programming process is now complete.
de
en
fr
nl
27