Intermediate Position - Becker VarioControl VC420-II Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Intermediate position II
Application
Roller shutter
Awning
Venetian blind
Note
This function allows you to open the curtain from the lower limit po-
sition until the desired intermediate position II is reached. Both limit
positions must be set before the intermediate position II is set.
a) Setting the intermediate position II
1. Travel the curtain from the lower limit position to the desired intermediate
position II.
2. Press the STOP button and, within 3 seconds, also press the UP button and
hold the two buttons down.
The shutter will "nod" to confirm.
The intermediate position II is now saved.
b) Checking the intermediate position II
1. Press the UP button twice within one second.
The curtain runs to the intermediate position II.
c) Deleting the intermediate position II
1. Travel the curtain to the intermediate position II.
2. Press the STOP button and, within 3 seconds, also press the UP button and
hold the two buttons down.
The shutter will "nod" to confirm.
The intermediate position II is now deleted.
Information for the operation of the venetian blind
If an intermediate position II is saved, the blind will run to this position
after travelling to intermediate position I. If there is no intermediate
position I saved, the blind will run to intermediate position II after the
running time has elapsed.
32
Function
Ventilation
Fabric tension
Slat rotation