Led Status - Lorentz PSk2-7 Manuel D'installation Et De Fonctionnement

92 SmartSolution
Wiring
The wiring must be done by qualified staff only. In the kit
there is a green 2-pin plug with two pre-assembled cables
(black and red). The 2-pin plug must be removed from the
board before wiring. The corresponding socket on the right
upper edge of the board is labeled with the correct cable
configuration. ("Figure 62: SmartStart board" on page
91)
Battery
Use the 2-pin plug ("Figure 62: SmartStart board" on page
91) with the pre-assembled cables. The red cable is for
plus (+), the black cable is for minus (-).
Make sure the cables are securely mounted to the battery.
Ensure and check the correct polarity.
Remove the battery fixing. Slide in the battery. Ensure the
battery is correctly seated and secure it with the battery
fixing.

15.3.7 LED status

A flashing red LED indicates that the battery voltage is
low.
A permanent green LED indicated that the power of the
PSk2 is on.
A flashing green LED indicates that the power of the PSk2
is off. PumpScanner connection is possible due to battery
power supply.
A permanent yellow LED indicates that the generator
relais is switched on.
A permanent blue LED indicates that the auxilliary relais
is switched on.