Psk2 Setup With Pumpscanner - Lorentz PSk2-7 Manuel D'installation Et De Fonctionnement

10

PSk2 Setup with PumpScanner

3 PSk2 Setup with PumpScanner
PumpScanner for Android
correct PSk2 controller setup. Setting up the pump
and mandatory accessories, e.g. the Sun Sensor, is
required for full performance and to not void the
warranty.
The PSk2 controller is a new generation solar pump control-
ler for LORENTZ PSk submersible and PSk surface pumps. It
utilizes a wireless Bluetooth
Android -based smartphone or tablet running the LORENTZ
®
PumpScanner software.
PumpScanner is available through our partner extranet
website "partnerNET". The PumpScanner software makes
configuration quick and simple.
Every PSk2 controller is shipped with the same default setup
and must be configured by the installer using PumpScanner.
PumpScanner holds the latest versions of
pump system firmware as well as new
features. We highly recommend you
update PumpScanner prior to each system
install to ensure you have the latest
version.
There is a logical process to follow when installing
PSk2 systems:
1. Make sure the latest version of PumpScanner is
installed on your Android device
2. Make sure you have registered the PSk2 system on
Sites in partnerNET and updated your license list in
PumpScanner
3. Complete the physical installation as per the PSk2
manual
4. Connect power but do not start the pump (toggle
switch on controller is in position "OFF")
5. Connect to the pump controller using PumpScanner
as per the PumpScanner manual
6. Check the controller firmware version as per the
PumpScanner manual and update it if asked to do so
by PumpScanner
7. Configure the pump controller using PumpScanner as
per the PSk2 manual and PumpScanner manual
8. Switch on the controller
9. Optional: Install the PS Communicator as per the PS
Communicator manual
is an important tool for
™
connection to connect to an
®
PSk2 configuration – PSk2 simplifies the installation
process by using our PumpScanner Android App to program
the parameters of the controller. This programing is very
simple and only requires the correct controller and pump to
be selected as well as the setup of parameters according to
the COMPASS report. Using PumpScanner you can look at
the real-time and historic performance of the pump.
PumpScanner – You will need to install PumpScanner on
an Android device (smartphone or tablet). No SIM card or
®
contract is required, the communication is via Bluetooth. You
can download and license PumpScanner here:
http://www.lorentz.de/psdl
or use the following QR code:
Read the PumpScanner manual to understand how to link
the controller to your Android device.
Configuration in the workshop – You can pre-con-
figure the PSk2 system in your workshop before attending
the Site, this provides a good opportunity to make all of
the configuration settings in a controlled environment. By
connecting a 12-24 V DC supply (battery or power supply)
to terminals 17 and 18 the PSk2 control and logic circuits
will be powered allowing you to connect via PumpScanner
and configure the system.
PumpScanner is free of charge for all users. To get
access to your pump after installing the app, please
ask your LORENTZ partner to register it for you.
Please note: Some functions are limited to technical users
only. Please check the PumpScanner manual in partnerNET.