Led Status - Lorentz PSk2-7 Manuel D'installation Et De Fonctionnement

11.1 LED Status

System status indicator
Pump status indicator
Source low indicator
Remote switch indicator
Local communication
Operating the Pump
green light Power is present, ON/OFF switch is in ON position
green light Pump in standby mode due to settings ON/OFF switch
flashing in OFF position
no light Insufficient power input
green light Pump is on
green light
Number of flashes indicates pump speed
flashing
red light Pump stopped, check with PumpScanner
red light
Flashing indicates overtemperature of the controller
flashing
Well probe or water sensor has detected a low water
red light
source
red light Flashing indicates "source low" incident since the
flashing controller was switched ON
no light Water source is okay
red light Remote switch triggered, pump stopped
red light External power error (SmartPSUk2), refer to "15.2
flashing SmartPSUk2" on page 82
no light Remote switch not triggered
blue light Bluetooth connection active
blue light
Update
flashing
no light Currently no Bluetooth communication
69