Pipes With Thread - Lorentz PSk2-7 Manuel D'installation Et De Fonctionnement

Figure 30: Connecting the next piece of pipe
After connecting the two pipes, lift the whole pump system
again to dismantle the lower clamp above the pump end.
This procedure has to be followed for every piece of pipe
until the pump has reached the desired installation depth.
WARNING – If the pump is not lifted
before the clamp is being dismantled the
pump will sag. This could cause serious
injuries to the installer and damage to
the pump system.
Pump Installation
Figure 31: Dismantling the lower clamp
Note: Pay attention to "9.2.3 Preparing
the installation" on page 43"and "9.2.4
Installation Depth" on page 45.

9.2.7 Pipes with thread

If you use pipes with a thread instead of a flange the instal-
lation is basically the same.
The threads have to be sealed with hemp- or teflon tape.
Make sure that the threads cannot work loose over time.
49