Setting The Shock Absorbers - Reely Audi RS5 Notice D'emploi

c) Setting the Shock Absorbers
B
B
C
C
A
A
Front axle Rear axle
The shock absorbers at the vehicle's front and rear vehicle axles can be mounted in different positions at the lower
transverse link (A) and at the damper bridge (B).
The spring-pre-tension can be adjusted by turning a knurled screw (C) at the upper end of the shock absorber.
Always set the shock absorbers for one axle evenly (at the left and right wheels of the front or rear axle). Otherwise,
driving behaviour will be influenced negatively.
If the setting is too stiff, the vehicle will jump even on a small unevenness, and the wheels will lose touch with the
ground. This will cause a lower acceleration. When the setting is too soft, the vehicle will rebound too strongly, and
the chassis will touch the ground.
Optional accessories (not included in the delivery; can be ordered separately) that can be used include
springs with a different stiffness or damper oil of a different viscosity for filling the shock absorbers.
Just as with a „real" car, the shock absorbers (or the rubber seals in them) on the model car are a wearing part. If
oil is running from the shock absorbers (e.g. lower transverse link strongly oiled, dripping traces), the seals or shock
absorbers must be replaced.
43