Cleaning And Maintenance; General Information; Before Or After Every Drive; Setting The Tooth Backlash - Reely Audi RS5 Notice D'emploi

11.

Cleaning and Maintenance

a) General Information
Before cleaning or servicing, turn the speed controller off and completely disconnect the drive battery from the speed
controller. If you have driven the vehicle before, let all parts (e.g. motor, speed controller, etc.) cool down completely
first.
Clean the whole vehicle of dust and dirt after driving, e.g. with a long-haired clean brush and a vacuum cleaner.
Compressed air aerosols can also be helpful.
Do not use cleaning aerosols or conventional household cleaners. This may damage the electronics and lead to
discolouration of the plastic parts or the body.
Never wash the vehicle with water, e.g. using a high-pressure cleaner. This will destroy the engine, speed controller
and receiver. The vehicle must not become damp or wet!
A soft cloth, slightly dampened, can be used to wipe the car body. Do not rub too firmly in order to avoid scratch
marks.
b) Before or after Every Drive
Motor vibrations and shocks during driving can loosen parts and screw fittings.
Therefore, check the following items before and after every drive:
• The tight fit of wheel nuts and of all vehicle screw fittings
• Fastening of speed controller, on/off switch, receiver
• Glue-connections of tyres and runs or tyre condition
• Attachment of all cables (they must not get into movable parts of the vehicle)
Also check the vehicle for damage before or after every use. If you find any damage, the car may not be
used anymore and has to be taken out of operation.
Only original spare parts must be used to replace worn vehicle parts (e.g. tyres) or defective vehicle parts
(e.g. a broken transverse link).
c) Setting the Tooth Backlash
The distance between the motor pinion (A) and main pini-
on (B) must be as low as possible without the gears being
too tight.
How to achieve this?
Loosen the two motor attachment screws slightly. Then
push the motor with the motor pinion in the direction of the
main gear with light pressure.
The motor pinion and the main pinion now engage without
clearance. However, this is not perfect for the service life
of the gears!
44
B
A