Sawing With The Mitre Fence - Metabo PK 255 Instructions D'utilisation Originales

Setting the rip fence for ripping solid
wood
 Set the rear end of the rip fence
(67) at a position corresponding to
the midpoint between the saw
spindle and the saw blade tip .
A
Caution!
After every cutting operation use the
push stick to guide the workpiece care-
fully between the saw blade and the rip
fence to the rear area of the saw table
and remove it from the table.
Setting the rip fence for cutting
boards
Set the rear end of the rip fence

(68) to the maximum possible
length, or at least such that it is in
line with the saw spindle .
A
Caution!
After every cutting operation use the
push stick to guide the workpiece care-
fully between the saw blade and the rip
fence to the rear area of the saw table
and remove it from the table.
67
Setting the rip fence for cross-cut-
ting narrow workpieces
 Set the rear end of the rip fence
(69) such that it is in line with the
saw blade tip.
A
Danger!
If the workpiece is wedged it can be
flung out uncontrolledly. Adjust the rip
fence such that the workpiece ends are
not simultaneously contacting the saw
blade and the rip fence.
68
A
Caution!
After every cutting operation use the
push stick to guide the workpiece care-
fully between the saw blade and the rip
fence to the rear area of the saw table
and remove it from the table.
8.4 Sawing with the mitre
fence
1. Insert the mitre fence into the table
slot from the table's front edge.
2. Set the desired mitre angle and se-
cure in place with the locking lever
(72).
70
3. Align fence extrusion and arrest in
position with knurled thumb screws
(70).
A
Caution!
The plastic lug (71) must be at a di-
stance of at least 10 mm from the cut-
ting line.
4. Set the saw blade cutting depth and
secure in place (see "Setting the
depth of cut" in chapter "Operati-
69
on"). The blade guard must rest with
its front edge on the workpiece.
5. Set the saw blade tilt angle and se-
cure in place (see "Setting the saw
blade tilt" in chapter "Operation").
6. Start motor.
7. Slide the workpiece against the mit-
re fence, hold and cut in a single
pass.
8. Turn machine off if no further cutting
is to be done immediately after-
wards.
ENGLISH
71
72
31