Sulky VISION-X DPB Notice Originale page 125

Quick start-up
a) "REG" (settings) menu
- 1 -
Select the REG (Settings) menu.
- 2 -
Program the INDEX
- 3 -
Check that all the parameters have been saved
correctly: speed coefficient
.
- 4 -
Select your fertilizer
SPEED selection (Slow, Medium or Fast) and the
use of the application rate
(consult the machine instruction manual).
- 5 -
Select then
the tare (if the machine is fitted with static weigh-
ing device)
Note:
You may now fill the spreader hopper.
b) "INFO" menu
- 1 -
Select the INFO menu.
- 2 -
Select mode.
- 3 -
Reset each counter to zero using the
function.
- 4 -
As soon as the alarm sounds and the bell appears
on the screen, select
Select OK to return to the initial screen.
- 5 -
Select if you wish to save your work.
- 6 -
Check that the rotation speed of the spreading
system is adequate (consult the machine's
instruction manual).
c) "EPAN" (spreading) menu
- 1 -
Select the EPAN (Spreading) menu.
2
- - Check:
• That the product selection is correct.
• That the conveyor belt speed is correct
= Slow,
= Medium, (or without gearbox)
= Fast,
and that it corresponds to the combination fitted on
the gearbox at the rear of the machine.
• That the position of the application rate reducer,
= NON (NO),
sponds to the position on the machine.
- 3 -
Programme the dose per hectare, use the numeric
keypad directly and confirm with
that corresponds to the tyres.
and working width
, check the conveyor belt
REDUCER (Yes or No).
then , and perform
(RTZ)
to find out why.
= OUI (YES), corre-
.
- 6 -
Select or (key available only with booms
) for the adjustment of the opening of
the boom valves (Consult the specific instructions
for AUTOMATIC VALVES).
- 4 -
Carry out a flow rate test
(see section Setting the flow rate").
2
C
- 5 -
You can adjust your application rate / hectare:
select or ,then return to the initial rate by
o r which will be displayed.
selecting
- 6 -
You can adjust
the right-hand side by selecting
or the left-hand side by selecting
Return to the same right / left hand application
rate by selecting .
- 7 -
You may activate the Tribord 3D (with granule
discs ), or the working width sectioning
(with booms
EN
).
3
125