Dismantling The Bicycle Rack; Mounting The Short Tensioning Straps; Mounting The Bicycles To The Rear Rack - EUFAB CROW PLUS Manuel De L'opérateur

Masquer les pouces Voir aussi pour CROW PLUS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.3 DISMANTLING THE BICYCLE RACK

In order to unfold the bicycle rack, start by swivelling the rear lights outwards. The light mounts are clipped onto the rack table. Pull the light mounts out of
the clips. Pull the locking mechanism back (Position 1 in Figure 12). Hold the locking mechanism in this position. Swivel the light mount out fully (Position 2 in
Figure 12). Now release the locking mechanism (Position 3 in Figure 12), the light mount is now secured to prevent it from folding back in.
Fold open the bicycle rack as shown in the following Figures.
1. Fold out the right rear light
3. Fold out the right wheel rail

5.4 MOUNTING THE SHORT TENSIONING STRAPS

Figure 13: 6 x short tensioning strap
Insert the short tensioning strap from the inside to the outside below the bike holder and then from the outside to the inside through the slots of the bike
holder (Figure 14). For the rear wheel of the bicycle, use the centre slot of the wheel holder, for the front wheel, use the two outer slots (two tensioning straps
to prevent the front wheel from turning).

5.5 MOUNTING THE BICYCLES TO THE REAR RACK

The first bicycle is placed in the first bicycle rail (closest to the vehicle) and secured to the U-shaped bracket with the short frame holder. To do this, use the side
of the frame holder with the tensioning strap to secure to the bicycle frame. The wheels are secured by placing the tensioning straps around the wheel rim of
your bicycle and tightening the straps. Caution: The front wheel must be secured with two small tensioning straps to prevent it from turning (Figure 15). The
second bicycle is used placed in the second rail, facing the opposite direction and secured to the U-shaped bracket with the long frame holder. The wheels are
secured in the same way as for the first bicycle. It may be necessary to offset the individual bicycles differently on the rack to ensure that the frame holders may
be correctly secured. Now secure the bicycles with the long safety strap. Wrap the safety strap through the bicycle frames and the U-shaped bracket and tighten.
(See Figure 16)
Without this safety strap, the bicycle rack may not be used.
Figure 15: Tensioning straps for front wheel
Safety strap
Figure 12: Locking the light mounts
Bild 14: Montage Spanngurte
Figure 16: Safety strap
2. Fold out the left rear light
4. Fold out the left wheel rail
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

11582

Table des Matières