Transport; Storage; Guarantee; Possible Faults - ATIKA KGSZ 305 Notice Originale

6. Unscrew the hexagonal screw (37) for the saw blade (left-
handed thread!) using the supplied tool (45).
7. You can now remove the front saw blade flange (38), the
saw blade 39), the reducing washer (40) and the rear saw
blade flange (41). N
Clean the saw blade flanges and the reducing washer
(38, 40 and 41).
8. Put the rear saw blade flange and the reducing washer (40)
on the shaft again.
9. Insert a new saw blade.
Pay attention to the correct running direction of the saw
blade: The arrow on the saw blade and the arrow on the pro-
tective cover must point in the same direction!
10. The further assembly is now done in reverse sequence.
11. Check the pendulum cover for its correct functioning before
proceeding.
Replacing the carbon brushes
Replace the carbon brushes once they have been worn down to
approx. 4 mm.
1. Remove the carbon brush cover (4) on the side of the motor
cover by turning it counter clockwise using a suitable screw
driver.
2. Remove the carbon brushes; note the position of the spring
retention.
3. Insert the new carbon brushes (44) observing the correct
position of the spring retention.
4. Replace the carbon brushes only in pairs.
5. Screw in the carbon brush cover (4) again.
Replacing the table insert
Immediately replace a worn or damaged table insert.
1. Loosen the screws of the table insert (9) and remove them.
Insert a new table insert and screw it tightly in place.
2.

Possible faults

Before each fault clearance
− Switch off device
− Wait for standstill of the saw blade
− Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after
switching on or switches off
during idle running
Motor hums but does not start • Spindle lock engaged
No crosscut function
Saw blade jams while cutting
L
O
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Transport locking pin not removed
• Locking device for pendulum cover not opened
• Saw blade is dull
• Feed is too great

Transport

Remove mains plug before each transport.
Before each transport:
− Position saw head vertically
− Turn rotary table to 0°
− Push saw head down and engage the transport locking
pin (5)
− Remove the support arms (18) and the vise assembly
(20)
− Secure the pulling device!

Storage

Remove the mains plug from the socket.
Store unused equipment in a dry, locked place out of the
reach of children.
Before extended storage, please observe the following to
increase the service life of the device and to ensure smooth
operation:
− thoroughly clean the saw
− treat all movable parts with an environmentally friendly oil
Never use any grease!

Guarantee

Please observe the enclosed terms of guarantee.
Removal
• Check safety fuse
• Check cable, no longer use defect cable
• Have motor or switch checked by an ap-
proved electrician or replaced by original
spare parts
• Loosen saw blade locking device (42)
• Pull out transport locking pin (5)
• Open locking device (17)
• Replace saw blade (39)
• Allow motor to cool and proceed working with
less pressure
25