Automatic Icemaker - GE Profile 22 Manuel D'utilisation Et D'installation

About the automatic icemaker.
A newly installed refrigerator may take 12 to 24 hours to begin making ice.

Automatic Icemaker

approximately 100–130 cubes in a 24-hour period, depending
on freezer compartment temperature, room temperature,
number of door openings and other use conditions.
If the refrigerator is operated before the water connection is
made to the icemaker, set the power switch in the OFF position.
When the refrigerator has been connected to the water supply,
set the power switch to the ON position.
A newly installed refrigerator may take 12 to 24 hours to begin
making
ice cubes.
water.
to clear.
Be sure nothing interferes with the sweep of the feeler arm.
stop producing ice.
It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will become cloudy,
taste stale and shrink.
14
Special note about dispenser models:
Some models have a tilt-out ice bin. The bin can be tilted out
as shown in the illustrations, and it will hold itself up while you
sure to put the bin back in place before closing the door.
To restore your ice level from an empty bucket stage, the
following steps are recommended:
dispense 3 to 4 cubes.
After an additional 6 hours, dispense 3 to 4 cubes again.
These steps will restore your ice level in the shortest amount
of time.
Icemaker
Feeler Arm
(on some models)
NOTE:
In homes with lower than average water pressure,
you may hear the icemaker cycle multiple times
when making one batch of ice.
Icemaker
Green
Power Light
Feeler Arm
(on some models)