Automatic Icemaker - GE GZS22DSJSS Guide D'utilisation Et D'entretien Rapide

About the temperature controls.
Not all features are on all models. Your controls may be similar to the following:
The temperature controls are preset in the factory at 37°F for the refrigerator
compartment and 0°F for the freezer compartment. Allow 24 hours for the
temperature to stabilize to the preset recommended settings.
The temperature controls can display both the SET temperature as well as the actual
temperature in the refrigerator and freezer. The actual temperature may vary slightly
from the SET temperature based on usage and operating environment.
About the ice and water dispenser.
Spill
Shelf
About the automatic icemaker.
A newly installed refrigerator may take 12 to 24 hours to begin making ice.

Automatic Icemaker

The icemaker will produce seven
100–130 cubes in a 24-hour
period, depending on freezer
compartment temperature,
room temperature, number of
door openings and other use
conditions.
Throw away the first few batches
of ice to allow the water line to
clear.
CAUTION
Avoid contact with the moving parts of the ejector mechanism, or with the heating element that releases the cubes.
Do not place fingers or hands on the automatic ice making mechanism while the refrigerator is plugged in.
FEATURES
(Not all features are on all models)
The spill shelf is not self-draining. To reduce water spotting, the shelf and its grille should be cleaned regularly.
If no water is dispensed when the refrigerator is first installed, there may be air in the water line system.
Press the dispenser arm for at least two minutes to remove trapped air from the water line and to fill the
water system. To flush out impurities in the water line, throw away the first six glassfuls of water.
CAUTION
Never put fingers or any other objects into the ice crusher discharge opening.
Removing Ice Bin
(dispenser models)
The ice bin is heavy when full.
Set the power switch to the OFF
position before removing the bin.
When replacing the bin, be sure to
press it firmly into place. If it does not
go all the way back, remove it and
rotate the drive mechanism 1/4 turn.
Then push the bin back again.
Door Alarm
(on some models)
To set the alarm, press this pad until the indicator light comes on. This alarm will
sound if either door is open for more than 3 minutes. The light goes out and the
beeping stops when you close the door.
TurboCool
TM
(on some models)
TurboCool ™ rapidly cools the refrigerator compartment in order to more
quickly cool foods. Use TurboCool ™ when adding a large amount of food to the
refrigerator compartment, putting away foods after they have been sitting out at
room temperature or when putting away warm leftovers. It can also be used if the
refrigerator has been without power for an extended period.
NOTES: The refrigerator temperature cannot be changed during TurboCool ™.
The freezer temperature is not affected during TurboCool ™.
When opening the refrigerator door during TurboCool ™, the fans will
continue to run if they have cycled on.
Express Chill
(on some models)
ExpressChill TM cools the ExpressChill drawer in the refrigerator compartment to
allow items in this drawer to cool faster. In most models this feature lowers the
drawer temperature for a set time length (45 min.). In other models the time length
can be varied (continue pressing the pad until the light appears next to the desired
time length).
To stop this feature before the set time is up, press the pad until no options are
selected.
Quick Ice
(on some models)
When you need ice in a hurry, press this pad to speed up ice production. This will
increase ice production for the following 48 hours or until you press the pad again.
(on some models)
Icemaker
Feeler Arm
Icemaker
Green
Power Light
Feeler Arm
(on some models)
3