Product Description And Specifications; Intended Use; Product Features - Bosch GCD 12 JL Professional Notice Originale

OBJ_BUCH-1938-003.book Page 19 Friday, December 16, 2016 9:57 AM
 Do not use any optical instruments such as binoculars
to view the radiation source. Doing so can damage your
eye.
 Do not direct the laser beam at persons who are looking
through binoculars or similar instruments. Doing so can
damage their eye.
 Do not make any modifications to the laser equipment.
The setting options described in these operating instruc-
tions can be used safely.
 Secure the workpiece. A workpiece clamped with clamp-
ing devices or in a vice is held more secure than by hand.
 Products sold in GB only: Your product is fitted with a
BS 1363/A approved electric plug with internal fuse
(ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should
be cut off and an appropriate plug fitted in its place by an
authorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only: Use a residual current
device (RCD) with a rated residual current of 30 mA or
less.
Symbols
The following symbols can be important for the operation of
your power tool. Please memorise the symbols and their
meanings. The correct interpretation of the symbols helps
you operate the power tool better and more safely.
Symbol Meaning
 Laser radiation
Do not expose users of telescopic op-
tics
Class 1M laser product
 Keep hands away from the cutting ar-
ea while the machine is running. Dan-
ger of injury when coming in contact
with the saw blade.
 Wear ear protectors. Exposure to
noise can cause hearing loss.
 Wear safety goggles.
 Wear a dust respirator.
Bosch Power Tools
Symbol Meaning
Observe the dimensions of the saw blade.
The hole diameter must match the tool
spindle without play. Do not use reducers
or adapters.
Product Description and
Specifications
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.

Intended Use

The machine is intended for stationary use with saw blades to
perform lengthways and crossways straight cuts and miter
angles to 45° in metal materials without the use of water.

Product Features

The numbering of the components shown refers to the repre-
sentation of the power tool on the graphic pages.
1 Locking lever
2 Laser protection cap
3 Spindle lock
4 Retracting blade guard
5 Chip box
6 Angle stop
7 Clamping spindle
8 Quick-release button
9 Spindle handle
10 Clamping lever of the saw-table extension
11 Saw-table extension
12 Hex key (size 6 mm)/cross-head screwdriver
13 Tension handle to lock the angle stop
14 Transport safety-lock
15 Blade guard
16 Handle
17 On/Off switch
18 Laser warning label
19 On/Off switch for laser (cutting line indication)
20 Transport handle
21 Cover plate
22 Bracket
23 Mounting holes
24 Chip drawer
25 Saw table
26 Lower fastening screw
(cover plate/retracting blade guard)
English | 19
1 609 92A 340 | (16.12.16)