Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Symbols and their meaning
Oil the power tool as necessary at the
points indicated.
Protection class II power tools are
strengthened or double-insulated.
The CE mark provides confirmation from
the manufacturer that the power tool
complies with the applicable EU Direct-
ives.
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended use
The power tool is a stationary machine for cutting in a
straight line with and against the grain in hardwood, soft-
wood, chipboard and fibreboard. Mitre angles of –60° to
+60° as well as bevel angles of -2° to 47° are possible.
It is also possible to saw aluminium profiles and plastic using
the appropriate saw blades.
Product Features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1)
Guide groove for parallel guide
(2)
Scale for spacing between saw blade and parallel
guide
(3)
Angle guide
(4)
Recessed handles
(5)
Guide groove for angle guide
(6)
Protective cover
(7)
Saw table
(8)
Riving knife
(9)
Anti-kickback pawls
a)
(10)
Parallel guide
(11)
V guide groove on the saw table for the parallel
guide
(12)
Mounting holes
(13)
Carrying handle
(14)
Saw table expansion
(15)
Fixing clip for the GTA 600 saw stand
(16)
Clamping handle for saw table expansion
Bosch Power Tools
(17)
Locking lever for setting the bevel angle
(18)
Hand wheel
(19)
Crank for raising and lowering the saw blade
(20)
On/off switch safety flap
(21)
Hex key (2 mm)
(22)
Hex key (5 mm)
(23)
Ring spanner (23 mm)
(24)
Push stick
(25)
Adjusting screw for adjusting the clamping force of
the parallel guide
(26)
Table insert
(27)
Saw blade
(28)
Magnifying glass
(29)
Profile rail
(30)
Cable holder
(31)
Holding clip for storing the additional parallel
guide
(32)
Chip ejector
(33)
Dust extraction adapter
(34)
Bracket for storing the protective cover
(35)
Clamping lever for riving knife
(36)
Hex socket screws for riving knife
(37)
Positioning pins for riving knife
(38)
Recesses for table insert
(39)
Clamping lever for protective cover
(40)
Guide pin for protective cover
(41)
Clamping handle for parallel guide
(42)
V guide for parallel guide
(43)
Additional parallel guide
(44)
"Additional parallel guide" fastening set
(45)
Guide rail for angle guide
(46)
"Profile rail" fastening set
(47)
Fastening screw for chip ejector
(48)
Push buttons for retracting the guide bolt of the
anti-kickback pawls
a)
(49)
Clamping nut
(50)
Spindle locking lever
(51)
Clamping flange
(52)
Tool spindle
(53)
Mounting flange
(54)
Angle indicator (vertical)
(55)
Scale for bevel angles
(56)
Locking knob for all mitre angles
(57)
Angle indicator on the angle guide
(58)
Saw table spacing indicator
(59)
On button
(60)
Knurled nut for profile rail
English | 19
a)
1 609 92A 6YX | (01.09.2021)
Publicité
Table des Matières
