Safety; Area Of Application; Improper Usage Violating The Regulations; Climbing Into The Separator - ACO Oleosmart-C-OST Instructions De Service Et De Maintenance

Operating and maintenance instructions
2

Safety

2.1

Area of application

These instructions apply to separators for
mineral light liquids. The separators com-
ply with Separator Class I or II pursuant to
EN 858 in conjunction with DIN 1999-100
2.2

Improper usage violating the regulations

The regulations governing the use of the
separator are considered to have been
violated when the system is not used or
connected in accordance with the descrip-
tions defined in EN 858, DIN 1999-100
and in DIN 1999-100. The manufacturer
2.3

Climbing into the separator

Warning
Climbing into the separator is only permit-
ted when observing all of the relevant
accident protection regulations in your
country at the time planned for entry.
2.4

General safety instructions

Warning
The safety instructions must be strictly
followed. Failure to follow the instructions
properly can lead to material damage or
injury.
Warning
Smoking and naked flame are strictly for-
bidden anywhere in the area surrounding
the system.
2.5

Instructions on the installed devices

Caution
The installed fittings (e.g. inlet structure,
outlet structure, coalescence element,
etc.) are designed for operation within a
separator system. They must not be mis-
used as steps for operatives or as resting
places for heavy cleaning equipment,
etc. They are not designed to carry loads
of this kind.
Page 20 of 51
and DIN 1999-101. The separator tank
consists of reinforced concrete or poly-
mer concrete. It is designed for ground
installation.
is not liable for any damage arising from
improper use which violates the regula-
tions. It is forbidden to make unauthorised
changes or modifications to the system,
and such actions lead to the immediate
termination of the warranty rights.
You can obtain accident protection re-
gulations from your responsible district
accident insurance association.
Warning
The separator system is defined as a
zone 0 explosion hazard area. Only autho-
rised properly trained staff are therefore
allowed to carry out work on the electrical
components of the separator (where pres-
ent).
Achtung
Adhesive safety instruction labels must be
replaced if they become detached or
illegible.
Warning
Stepping onto any of the installed fittings
carries with it a risk of falling, especially
by the breakage of the installed fittings,
because the strength of the installed fit-
tings is not designed to carry the weight
of operatives.
Environmental Protection
Problem-free operation and compliance
with the safety regulations can only be
guaranteed by the system when it com-
plies one hundred per cent with the
model as produced by the manufacturer.
Caution
Aggressive substances or chlorinated
cleaning agents must not get into the se-
parator as they can destroy the coating.
Warning
Do not enter the separator without breath-
ing apparatus or before previously testing
the gas concentrations, and do not enter
the separator without safety equipment
(see the relevant accident prevention
regulations in your country).