Data Entry - Hach ORBISPHERE 6110 Package Analyzer V3 Manuel D'utilisation Simplifié

5.4 Data entry

When a text box (alphanumeric field) is selected for data entry, a
virtual keyboard appears on screen. This is used in a similar way
to a standard PC keyboard. When data entry is complete press
the Enter key on the right of the keyboard to confirm input and
exit the virtual keyboard.
Note: Use the Cap key at the bottom left of the keyboard to switch between
upper and lower case characters. This is important for case-sensitive
information such as passwords.
For convenience, selection through a possible large list of items
has been designed with a rolling list. Use the up and down arrows
at the side to navigate through the list or select one item directly.
Press Ok to confirm.
5.5 User identification
If access rights have been enabled (see
log on as an authorized user to get access to the instrument.
When the instrument is started for the first time, security is enabled. Refer to
To log on, press Login on the banner at the bottom of the screen. Enter a valid User ID and
Password combination in the boxes provided, and press Ok to continue. The details will be
displayed at the top left corner of the screen. Press the Ok button at the bottom left of the screen to
gain access to the menu.
Note: For security purposes, when the session inactivity delay period has expired the user is logged off
automatically.
Note: If the instrument security is enabled and the login credentials are not known, contact Hach Service support
with the recovery code to get the login credentials. The recovery code shows on the login window. The supplied
login credentials expire in one day. Make sure to change the login credential with known values.
5.6 Instrument options
A banner is displayed at the foot of each screen showing the available options:
• Standby - Press this button to leave the instrument in operational mode if there is a long time
delay between measurements. The screen will go blank, but can be reactivated by tapping it. Once
reactivated, you will need to enter a valid user ID and password combination if this has been set
up.
• Configuration - Refer to
• Calibration - Refer to
• Measurement - Refer to
• Analysis - Refer to
• Maintenance - Refer to
Note: If any of the options are unavailable for any reason (e.g. access level not high enough), they will be greyed
out.
5.7 Instrument status indicator
A colored LED indicator on the top right of the screen will indicate the current status of the
instrument:
• Green - no problems have been detected
• Yellow - a problem has been detected but is not serious enough to stop measurements being
taken
• Red - there is a serious problem with the system which must be corrected before any
measurements can be taken
Security management
Configuration on page 10
Calibration on page 16
Measurement process
Analysis on page 19
Maintenance on page 19
on page 13), it will be necessary to
on page 17
Start up on page 10.
English 9