Troubleshooting - arjo AtmosAir 9000A Manuel D'utilisation

Troubleshooting

Do not attempt troubleshooting outside this guide or where the solution recommends to
serious injury and / or product damage and will void all applicable warranties.
SYMPTOM
Green lamp on pump does not
light when power switch is set to
the ON position.
Mattress cover too wrinkled upon
removal from shipping container.
In use.
12
POSSIBLE CAUSE
Power cord may be unplugged.
Wall outlet may be controlled by
a wall switch.
Circuit breaker for wall switch may
be tripped or blown.
Power cord or power switch may be
damaged.
to open valves.
Internal components have not
accommodated to environment. This
Tubing not connected properly.
Tubing kinked.
Tubing disconnected.
Holes in or damaged to
SAT
Pump leak low pressure indicator
active.
Hoses not disconnected at mattress.
SOLUTION
Plug in power cord.
Reset circuit breaker or replace fuse.
Contact Arjo for assistance.
Apply weight to mattress to open valves.
Let mattress accommodate for 24 hours.
If problem continues, contact Arjo for
assistance.
Check tubing inside mattress for loose
connectors.
Check tubing inside mattress for possible
kinks.
Check tubing inside mattress for possible
disconnect.
system. Check system for holes or damage,
SAT
or contact Arjo for assistance.
Switch pump on.
Remove and replace pump.
Disconnect hoses at mattress or
reconnect pump.
Connect hose cap or reconnect pump.