Care And Cleaning; Fire Barrier; Cover Cleaning - arjo AtmosAir 9000A Manuel D'utilisation

Care and Cleaning

The following processes are recommended, but should be adapted to comply with local
institution protocols. If you are uncertain, you should seek advice from your local Infection
Control Specialist.
The AtmosAir MRS should be routinely decontaminated between patients and at regular
intervals while in use.
If a powered AtmosAir MRS, ensure power cord is unplugged from wall
outlet before performing care and cleaning.
Do not use Phenol-based solutions or abrasive compounds or pads
on the cover during decontamination process as these will damage
the surface coating. Do not boil or autoclave the cover.
or spills.

Fire Barrier

recommended that Personal Protective Equipment (PPE) be used during handling of
Fire barrier should be replaced if soiled or damaged.

Cover Cleaning

Sewn AtmosAir MRS (Top cover can not be removed from base)
1. If a powered MRS, unplug pump before cleaning.
2. Remove or push bed linens to center of mattress.
The sewn AtmosAir MRS cover is cleaned by wipe down methods only.
Do not launder as damage to the base may occur.
3. Wipe and rinse any soiling from the mattress surface and base. Use 1000 ppm
chlorine or 70% alcohol.
4. Rinse with a wet towel to remove chemicals.
5. After wipe down, dry surface with towel.
6.
7. Clean pump and tubes (if needed) by wiping with a damp cloth.
9