Care And Cleaning; End Of Life Disposal - arjo Skin IQ 1000 Microclimate Manager Mode D'emploi

CARE AND CLEANING

During patient use, clean Skin IQ 1000 Coverlet by wiping with a mild soap and water solution. Do not launder
the Skin IQ 1000 Coverlet. The Skin IQ 1000 Coverlet is for single patient
use only.
Avoid spilling fluids on any part of the Skin IQ 1000 power supply. If spills do occur:
•
disconnect the power cord from the wall outlet
•
clean fluids from the product
Ensure that there is no moisture in or near the power supply and power plug
before reconnecting the power cord.

END OF LIFE DISPOSAL

The coverlet itself is a single patient use only product, but some of the items that come with it
can be reused if they are handled properly when removed. Follow the steps below to remove the
fan and dispose of all components of the Skin IQ 1000 MCM.
1. Disconnect power cord from wall outlet.
2. Disconnect power supply from fan.
Power supply and cord can be reused. Consider all facility policies and procedures
with regard to cleaning, inspection and reuse of electronic equipment. If not
reused, dispose of power supply per approved local institutional procedures.
3. Cut fan out of coverlet as shown.
4. Dispose of coverlet and fan according to approved
local institutional procedures.
Fan assembly contains electronic components
that may require alternate disposal than the
soft goods of the coverlet.
Improper disposal of any component may
result in regulatory non-compliance.
Fabric material used on the coverlet or any other textiles, polymers or plastic materials etc.
should be sorted as combustible waste.
Units have electrical and electronic components that should be disassembled and recycled per
Waste of Electrical and Electronic Equipment (WEEE) or in accordance with local or national
regulation.
EN
9