Publicité
BRKT
a
1
TILT CYLINDER ASSEMBLY
15 mm
2
ASSEMBLING THE TILT CYLINDER
ASSEMBLY
1. Install:
•
Free piston
NOTE:
Push the free piston down until it is fully
compressed at the bottom of the tilt cylin-
der.
2. Fill:
•
Tilt cylinder
Recommended Power trim and tilt
fluid
ATF Dexron II
NOTE:
Fill the cylinder with Power trim and tilt
fluid. Add Power trim and tilt fluid until it is
approximately 15 mm below the last thread
a
on the cylinder as shown.
3. Install:
•
Tilt ram assembly
NOTE:
When installing the tilt ram assembly.,
make sure that the tilt ram is fully extended.
4. Tighten:
•
Tilt cylinder end screw
Tilt cylinder wrench
YB-06175-2B/90890-06544
Tilt cylinder end screw
90 Nm (9.2 m
7-28
1
2
kgf, 66.4 ft
lb)
•
•
E
Publicité
Chapitres
