Publicité
POWR
a
a
CYLINDER HEAD
c
b
CHECKING OIL PUMP
Measure:
•
Clearance
•
Clearance
•
Clearance
Out of specification → Replace.
Clearance
a
0.03 - 0.15 mm
(0.001 - 0.006 in)
b
0 - 0.12 mm (0 - 0.005 in)
c
0.03 - 0.08 mm
(0.001 - 0.003 in)
CHECKING THE CYLINDER HEAD
1. Measure:
•
Cylinder head warpage
Out of specification → Reface.
Warpage limit
0.1 mm (0.004 in)
Resurfacing steps
(1) Place a 400 - 600 grit wet sandpaper on
the surface plate.
(2) Resurface the cylinder head using a fig-
ure-eight sanding pattern.
NOTE:
To ensure an even surface, rotate the cylin-
der head several times.
2. Measure:
•
Valve guide bore
Out of specification → Replace the
guide.
Valve guide bore limit
5.500 - 5.512 mm
(0.2165 - 0.2170 in)
5-30
a
b
c
a
E
Publicité
Chapitres
