Installing The Input Adaptor; Removing The Connector Cover - Sony PVM-2551MD Instructions D'utilisation

Installing the Input
Adaptor
Before installing the input adaptor, disconnect the power
cord.
1
Remove the panel of the optional input port.
2
Insert the input adaptor into the port.
3
Tighten the screws.
Removing the
Connector Cover
When the unit is shipped from the factory, a connector
cover is attached to the PARALLEL REMOTE
connector and the SERIAL REMOTE connector (RJ-
45).
To use the connector, remove the connector cover as
follows.
Before removing the connector cover, disconnect the
power cord.
Connector cover
1
Remove the screw of the connector cover.
2
Remove the connector cover.
Save the screw and cover, so that you can reattach the
cover if necessary.
Caution
These connectors are designed to allow direct contact
with conductive circuits. Weak voltage may be present
because of a failure in this unit. To prevent patients from
touching these connectors accidentally, attach the
connector covers when the connectors are not being
used to connect to other devices.
Installing the Input Adaptor / Removing the Connector Cover
61