User Config Menu; System Setting - Sony PVM-2551MD Instructions D'utilisation

Submenu
PICTURE CONTROL
70
Adjustment Using the Menus
Setting
Adjusts to monitor the picture more
clearly.
• SIZE H: Adjusts the horizontal
size of the picture. The
higher the setting, the larger
the horizontal size of the
picture. The lower the
setting, the smaller the
horizontal size of the
picture.
• SIZE V: Adjusts the vertical size
of the picture. The higher
the setting, the larger the
vertical size of the picture.
The lower the setting, the
smaller the vertical size of
the picture.
• SHIFT H: Adjusts the position of
the picture. As the setting
increases, the picture moves
to the right, and as the
setting decreases, the picture
moves to the left.
• SHIFT V: Adjusts the position of
the picture. As the setting
increases, the picture moves
up, and as the setting
decreases, the picture moves
down.
• DOT PHASE: Adjusts the dot
phase. Adjust the picture
further for a finer picture
after APA (page 74) is
adjusted.
• PITCH: Adjusts the horizontal
size of the picture with the
left side of the picture fixed.
The higher the setting, the
larger the width of the
picture. The lower the
setting, the narrower the
width of the picture.
• RESOLUTION: Sets when the
computer signal is input and
it is difficult to understand
the signal type such as
XGA/60 or WXGA/60
•XGA: Displayed as XGA
signal.
•WXGA: Displayed as
WXGA signal.
• RESET: Resets the value of
SIZE H, SIZE V, SHIFT H,
SHIFT V, DOT PHASE and
PITCH to the factory preset
value.

USER CONFIG menu

The USER CONFIG menu is used for setting the
system, multi display, function button, computer detect
and option DVI.
USER CONFIG
S Y S T E M S E T T I N G :
M U LT I D I S P L AY S E T T I N G :
F U N C T I O N B U T T O N S E T T I N G :
C O M P U T E R D E T E C T :
O P T I O N DV I S E T T I N G :

SYSTEM SETTING

USER CONFIG – SYSTEM SETTING 1/2
M AT R I X :
C O M P O N E N T L E V E L :
N T S C S E T U P :
G A M M A :
F O R M AT D I S P L AY:
L A N G U A G E :
I / P M O D E :
S C R E E N S AV E R :
USER CONFIG – SYSTEM SETTING 2/2
S D P I X E L M A P P I N G
C O M P O S I T E & Y / C :
R G B / C O M P O N E N T :
S P L A S H L O G O :
F L I C K E R F R E E :
Submenu Setting
MATRIX Applied to 480/60I or 480/60P
signal. Select 601 or 709.
COMPONENT LEVEL Selects the component level from
among three modes.
• SMPTE: for 100/0/100/0 signal
• BETA0: for 100/0/75/0 signal
• BETA7.5: for 100/7.5/75/7.5
NTSC SETUP Selects the NTSC setup level from
two modes.
The 7.5 setup level is used mainly
in North America. The 0 setup level
is used mainly in Japan.
xxx
xxxxx
x
xxx
xx
E N G L I S H
xxxxxxx
xx
xxxxxxx
xxxxxxx
xx
xx
signal