Sony PVM-2551MD Instructions D'utilisation page 72

Submenu
SD PIXEL MAPPING
SPLASH LOGO
FLICKER FREE
MULTI DISPLAY SETTING
USER CONFIG MULTI DISPLAY SETTING
M U LT I D I S P L AY E N A B L E :
D I S P L AY L AYO U T :
S U B I N P U T S E L E C T :
P O S I T I O N :
F R A M E :
S U B P I C T U R E S I Z E :
72
Adjustment Using the Menus
Setting
Selects SD picture size (pixels)
according to input signal format.
• COMPOSITE&Y/C: Set to
monitor the signal input
through the COMPOSITE
IN connector or Y/C IN
connector.
• RGB/COMPONENT: Set to
monitor the signal input
through the R/G/B IN
connector or Y/P /P IN
B R
connector.
When picture signals in the
size of 720 × 576 (50i)
(or 720 × 487 (60i)) are
input
Select 720 × 576 (or 720 ×
487). This is the default
setting.
When 702 × 576 (or 712 ×
483) is selected, all sides of
the input picture are cut off
by several pixels.
When picture signals in the
size of 702 × 576 (50i)
(or 712 × 483 (60i)) or
equivalent are input
Select 702 × 576 (or 712 ×
483).
When 720 × 576 (or 720 ×
487) is selected, a black
border (of several pixels
wide) appears around the
input picture.
Sets the splash logo display mode
on or off. To display the splash
logo, you need to write the splash
logo data. For details, consult your
Sony dealer.
Set this to ON to enable view
images without flicker.
The ON setting will eliminate
flicker, but quick-moving images
may exhibit contours or an
afterimage.
For details, see "About the function
assigned to the function button"
(page 74).
xxx
xxx
xxx
x
x
x
Submenu Setting
MULTI DISPLAY Selects ON to display the multi display
ENABLE and OFF not to display.
Notes
• When the frame frequency of the
main display is different from that of
the sub display, the picture may be
disturbed.
When no signal is input to the main
display, the picture may not be
displayed correctly.
• When you set SUB INPUT SELECT
to OFF, MULTI DISPLAY ENABLE
is set to OFF automatically.
• When MULTI DISPLAY ENABLE is
set to ON, APA (page 74) is not
available.
DISPLAY LAYOUT • POP: The sub display is put by the
side of the main display. The scan
mode can only be selected in the
main display.
• PIP: The sub display appears in an
inset window of the main display
(for 16:9 display only).
• SIDE BY SIDE: The main display is
put in the left side of the display
and the sub display is put in the
right side of the display. Either
NORMAL or FULL can be
selected for the scan mode in the
main and sub display. The scan
mode of the main and sub display
will change at the same time. You
cannot set a different scan mode
for each display.
To switch the scan mode, press the
function button assigned to change the
scan mode. See "FUNCTION BUTTON
SETTING" (page 73) and "About the
function assigned to the function button"
(page 73).
Note
When DISPLAY LAYOUT is set to
SIDE BY SIDE, CTI (page 69) is not
available.