Attaching The Input Adaptor; Removing The Connector Cover - Sony LMD-2110MD Instructions D'utilisation

Attaching the Input
Adaptor
Before attaching the input adaptor, disconnect the power
cord.
BKM-341HS
Note
Do not connect the equipment other than BKM-341HS.
It causes damage to the unit or the equipment.
42
Attaching the Input Adaptor / Removing the Connector Cover
Removing the
Connector Cover
When the unit is shipped from the factory, a connector
cover is attached to the PARALLEL REMOTE
connector.
To use the connector, remove the connector cover as
follows.
Before removing the connector cover, disconnect the
Tighten the screws.
power cord.
1
2
Save the screw and cover, so that you can reattach the
cover if necessary.
Caution
This connector is designed to allow direct contact with
conductive circuits. Weak voltage may be present
because of a failure in this unit. To prevent patients from
touching this connector accidentally, attach the
connector cover when the connector is not being used to
connect to other devices.
Remove the screw of the connector cover.
Remove the connector cover.
Connector cover