Mennekes AMTRON Xtra E Instructions D'installation page 72

Value Description
HCC3 HW Hardware version of the HC controller
Version
HCC3 SW
Software version of the HC controller
Version
HCC3 IO State Status of the HC controller's inputs
and outputs
HCC3 CP/PP Status of CP/PP signal contacts
State
HCC3 Error Code Error code of the HC controller
AMTRON Operating mode of the charging
Operating Mode station
 See Chapter 7.4 on page 32
AMTRON State Operating state of the charging
station
AMTRON
Connector system of the charging
Connector Type station
AMTRON No. of Number of mains phases
Phases
AMTRON Rated Maximum charging current
Current
AMTRON Serial Serial number of the charging station
Number
AMTRON Order Order number of the charging station
Number
AMTRON  No external temperature sensor
External
Temperature  External temperature sensor
Sensor
AMTRON Local  No internal circuit breaker and
Fuses Installed
 Internal circuit breaker and
AMTRON
 true: production settings read-
Production
Settings Write
 false: production settings write
Enabled
HCC3 Ethernet MAC address of the HC controller's
MAC Address LAN interface
HCC3 Total Sum of the charged energy in Wh
Energy
23
available
available
residual current circuit breaker
available
residual current circuit breaker
available
only
enabled
Menu "Installation Settings"
Fig. 23: Menu "Installation Settings"
The menu "Installation Settings" shows the settings
required for the setting-up process. For the required PIN,
refer to the set-up data sheet.
Value Description
AMTRON Maximum charge current in A specified
Installation during setting-up process.
Current
Home  No SMA SUNNY HOME MANAGER
Manager available
Installed  SMA SUNNY HOME MANAGER
available
 See Chapter 7.4.1 on page 37
External  >No external tariff-switching signal
Tariff Switch
available
Installed
 External tariff-switching signal
available
 See Chapter 5.4.5 on page 17
®
®