Dometic MCS5 Notice D'utilisation page 10

_BA_MCS.book Seite 10 Donnerstag, 2. April 2009 9:56 09
Operating
Heat Mode
When the Heat Mode LED is lit, only the heating systems are selected and
operated as required. Should the temperature rise above the set point, the
system will not automatically switch to the Cool Mode.
Automatic Mode
Automatic Mode provides both heating and cooling as required. The Heat or
Cool LED will be lit according to the mode required.
Temperature in a given mode is maintained within 2 °F (1.1 °C) of set point,
however a 4 °F (2.2 °C) difference is required to allow the Marine Climate
System to change modes.
Once the mode changes temperature will be maintained within 2 °F (1.1 °C)
of set point.
Manual Fan Mode
Manual Fan Mode allows to select the desired fan speed manually. When a
manual fan speed has been selected, the Fan LED will be lit. Manual Fan
Mode is sometimes preferred when room temperature is constantly changing
due to varying heat loads.
The fastest fan speed is represented by "6", the slowest represented by "1".
Press and hold the Fan Button during normal operation to select one of
the six manual fan speeds available.
Circulation Mode
When the system is off at the control panel the fan can be used to only
circulate the air.
Press and hold the Fan Button when the display is off until the desired
speed number appears in the window.
Release the Fan Button
The fan will run at the selected speed circulating the air without heating or
cooling.
Press the Power Button once to cancel the Circulation Mode and enter the
On Mode.
10
MCS5, MCS15