Main Menu Table - LORCH ControlPro Manuel D'utilisation

19

Main menu table

Main menu
M1 Secondary parameters
M2 Welding programmes
M3 Language
M4 Settings
- 50 -
Sub-menu
M2-1 Programme selection
FE
FCAW M.
FCAW R.
CrNi 308
CrNi 316
AlMg
AlSi
CuSi
CuAl
CrNi 307
0,6
0.8
0.9
1.0
1.2
1.6
CO2
Ar/15-25 CO2
Ar/5-15 CO2
Ar/2.5 CO2
Argon
M2-2 Special Programs
M2-3 Program list
Fe 0.6 AR/5-15 CO2
. . .
M2-4 Program details
Program name
Program package program no/revi-
sion no
Program ID/process
Program date/program version
M4-3 Mode cooling unit
Auto
On
Off
30 min.
See "18 Secondary Parameters Table" on Page 49
Here you can select the welding programme based on the
material-wire-gas combination
Material selection
Wire diameter selection
Shield gas selection
Here we list all the welding programmes present in the unit,
with the opportunity of selection
Here we show additional information about the selected
welding program.
Here you can select the menu language.
Aut = Automatic, on = On, oFF = Off, 30 = 30 min. On;
The cooling unit is available for the three welding processes
MIG/MAG, electrode and TIG and can be separately configured
in each case. To do this, first select the desired welding pro-
cess and then set the cooling system mode.
909.3059.9-03
Main menu table
Note
When using a gas-cooled torch, on a
water-cooled power source, the cooler in
the welding process MIG/MAG must be
switched off!
02.20