After Switch-On; Main Parameters; Torch With Remote Control; Secondary Parameters Menu - LORCH BasicPlus Manuel D'utilisation

2

After switch-on

After switch-on, the device always starts in the most recently
used welding process.
Starting in Electrode or TIG welding process
If the device was exited in the Electrode or TIG
i i
welding process, then, for safety reasons, it will
start in the Standby mode of the appropriate
welding method after switch-on.
9 After switch-on, the Electrode LED A24 or TIG LED A26 will
flash.
Ensure that the electrode, electrode holder or
TIG torch do not come into contact with the
workpiece or ground cable.
 Exit Standby mode by a brief press of the Welding process
button A32 or Mode button A33
3

Main parameters

Different main parameters are available/ad-
i i
justable, depending on the selected welding
process.
‰ The value of the following main parameters is displayed in
the left-hand 7-segment display A4.
– Wire feed speed A37
– Welding current A36
– Material thickness A35
 Select the desired value with the control knob A41.
‰ The value of the following main parameters is displayed in
the right-hand 7-segment display A12.
– Welding voltage/arc length in V A19
– Arc length in % A20
 Select the desired value with the control knob A44.
- 22 -
4

Torch with remote control

Fig. 2: Torch PowerMaster
B1
Torch display
Indicates the main parameter values and parameter
abbreviations (independently of the 7-segment dis-
plays A4 and A12).
A = Welding current
U = Welding voltage
t = Material thickness
F = Wire feed speed
Uc = Arc length
B2
Torch rocker
Changes the main parameter values (depending on
which value is shown on torch display B1).
B3
Mode torch button
Press briefly to display the main parameter abbrevia-
tion on torch display B1.
Press briefly again within 2 secs to switch to the next
main parameter.
The Mode torch button is blocked during the welding
process
5

Secondary parameters menu

 Press the Menu button A2 for 2 sec.
9 You are now in the Auxiliary Parameters menu.
 Use the rotary knob A41 to select the desired secondary
parameter.
 Use the rotary knob A44 to set the desired value.
 Save the set value by pressing the Save button A14.
 Exit the Secondary parameters menu by pressing the
Menu button A2.
‰ The following secondary parameters are available, de-
pending on the selected welding process and operating
mode.
909.3049.9-03
Secondary parameters menu
B1B2 B3
02.20