Maintenance; Accessories; Spare Parts; Service Key And Tightening Torques - WOHLHAUPTER DIGIBORE 501 Mode D'emploi

Battery changing (Fig. 10)
The two integrated batteries have a service
life of approx. 5500 adjustment cycles. We
recommend keeping replacement batter­
ies at hand at all times. If „Low battery"
is shown on the display, the batteries will
last for approximately 50 more adjustment
cycles. When the „Low battery" display
flashes, the batteries are flat and must be
replaced. When the batteries are exchang­
ed, the sealing ring in the cover must also
be exchanged, because this is the of pre­
venting coolant from entering the battery
compartment. Only batteries with the
following specification must be used for
operating this precision tool:
VARTA V392 SR 41 Sil ver oxide / Zinc
/ KOH-Electrolyte. Only these batteries
have been tested in relation to the high
centrifugal forces involved. To change the
batteries, open the battery compartment
③ (Figure 10). Use a Torx T 20 service
key to open the unit, remove the old
batteries and dispose of them correctly.
Close the battery compartment again
carefully.
Description of the metric display
① Battery charge display (Low battery)
② +/– sign
③ Decimal comma
④ Value displayed in mm
Description of the inch display
① Battery charge display (Low battery)
② – sign
⑤ Comma for inch display
⑥ Value displayed in inches
①
② ⑤ ③
Fig. 11
④⑥

5. Maintenance

The tool needs only to be cleaned
after use and the serrated body lightly
greased. To keep the tools in top class
condition and maintain their value, store
them in a dry place and occasionally
cover them with a light film of oil.

6. Accessories

The accessories are not included in the
equipment supplied and must be ordered
separately.
You can obtain the latest information
on accessories from the Wohlhaupter
product catalogue as well as from the
website: www.digibore.de

7. Spare parts

215 674 Threaded taper pin for
mounting accessories
415 353 Clamping screw for slide
clamping
415 896 Battery (always change
2 batteries)
501 016 Battery access cover
with sealing ring
415 895 Sealing ring for battery cover
115 576 Hexagon wrench SW 4
215 150 Service Key T20
8. Service key and tightening tor-
ques
Service Key
Threaded taper pin 115576
215674 Type B, s4
English
Torque
8 Nm
15