Maintenance And Cleaning; Repair - WOHLHAUPTER MVS Mode D'emploi

Do not use any kind of extensions
for clamping. By using a torque
higher than mentioned in our
table the bevel gear can be
damaged. In this case the bevel pinion
will be the rated break point to protect
the drill chuck against damage.
Fig. 3
4th step
Test the concentricity after clamping and
make sure that the tool is clamped safely.
Do not clamp
the tool with
tapered shafts.
5th step
The CNC drill chuck is ready for work and
can be clamped into the machine spindle
(Fig. 3).
6th step
To release the cutting tool please turn the
Allen-T-wrench counter clockwise and
remove the cutting tool.

3. Maintenance and cleaning

The CNC drill chucks are maintenance-
free.
The drill chucks should be cleaned after
use with a clean cloth to prevent corrosion.
Before storing the drill chucks please spray
oil on the surface to prevent corrosion.
Do not use compressed air to
clean the drill chucks because
fine chips could get into the
clamping mechanism.
Do not use any kind of solvent for
cleaning because this could cause
corrosion.

4. Repair

In case of repair please return your dama-
ged drill chucks. To ensure full guarantee,
proper function and a concentricity of min.
0.03 mm please make use of our repair
service.
By inserting the drill chuck into the machi-
ne spindle or the magazine please follow
the general instructions for use and the
safety tips of the machine manufacturer.
English
9