Balancing; Maintenance; Accessories; Spare Parts - WOHLHAUPTER VarioBore 536 Mode D'emploi

English
Example:
a)
b)
c)
4.3 Balancing (Fig. 11)
The tool is equipped with a groove for
inserting balancing weights ①.
Precision balancing is performed using up
to 6 balancing weights (usually the stand-
ard equipment with 4 is sufficient) and a
pre-balanced basic support with a balanc-
ing machine.
Markings ② on the tool mean that neutral
positions for the four balancing weights can
be set time and time again.
To install the balancing weights, first
remove the screw plug ③ and insert
the balancing weights into the T-shaped
groove. Finally, apply coating of Loctite 234
to screw plug, screw all the way in and then
tighten (tightening torque 8 Nm (70.81 in.
lbs.))
Notice:
It is not permitted to use the
tool without the bonded-in
18
screw plug ③ (Fig.11) in the balancing
groove inlet.
② ①
③
Fig. 11

5. Maintenance

No maintenance required!
To ensure the tool has a long service life, it
must be cleaned after use. A light film of oil
should be applied to the visible, uncoated
steel parts from time to time.

6. Accessories

Accessories are not included in the scope
of delivery and they must be ordered sep-
arately.
Information on accessories is available in
the Wohlhaupter product catalog and on
the Internet at:
www.wohlhaupter.com

7. Spare parts

215674 Threaded taper pin for fastening
accessories
070333 Threaded clamping pin for slide
clamping
536005 Balancing weight ①
incl. clamping screw 115470
115470 Clamping screw for balancing
weight
115119 Screw plug ③