WOHLHAUPTER VarioBore 536 Mode D'emploi page 15

Fig. 1
Mini boring tools (Fig. 1-1)
Mounting
The mini boring tools ③ are attached via
an adapter ④, in the slide with a thread-
ed taper pin ⑤. The mini boring tool
reaches its cutting position when the sur-
face ⑥ at the shank end makes contact.
Clamp it to the oblique surface with a
threaded taper pin ⑦ (tightening torque
4 Nm (35.40 in. lbs.)).
Fig. 1-1
Tool holders (Fig. 2)
Mounting
The tool holders ⑥ are fastened on a
clamping surface using a threaded taper
pin ⑤ in the slider.
⑤
Fig. 2
⑤ ④ ③
⑤
④ ③
⑥ ⑦
⑥
Serrated tool bodies and insert holders
(Fig. 3)
Mounting
The serrated tool bodies ⑦ are fastened
in the slider using a threaded taper pin ⑤.
To fasten the insert holders ⑧ in place,
they are mounted onto the K-profile of the
serrated tool body and clamped using the
fixing screw ⑨ (tightening torque 8 Nm
(70.81 in. lbs.). The insert holders can be
preset using the scale on the serrated tool
body and insert holders. The scale on the
insert holder is valid for a center slider
position (= 0).
⑤
Fig. 3
Serrated slide with coolant delivery sec-
tion (Fig. 4)
To fasten the serrated slide ⑩, the coolant
delivery section ⑪ is first fastened in the
slider using a threaded taper pin ⑤.
The serrated slide is aligned according to
the marking ⑫ and fastened in place using
the cap screws with washers (tightening
torque 4 Nm).
⑪ ⑤
Fig. 4
English
⑦ ⑧
⑩
⑫
⑨
15