Maintenance; Accessories - WOHLHAUPTER ALU LINE 364 Mode D'emploi

English
2a) To readjust the tool (i.e. increase
diameter)
Readjust the dial
required. The smallest value on the
dial will give a diameter adjustment
of 0.002 mm (0.0001")
or
2b) Setting the tool back (i.e. decrease
diameter)
– read off the value set on the tool
(fig. a, example: No. 21 on dial)
– turn the dial back (i.e. anti-clock -
wise) approx. half of one full turn.
Left turn direction (fig. b).
– set the new (smaller) value (fig. c)
example: no. 20 on dial).
metric:
a)
b)
c)
3. Tighten clamping screw
the thread pin, see technical data,
page 12.
10
7
by the value
inch:
6
. Torque for

6. Maintenance

For greasing the boring tool there is a
lubrication nipple on the facing side (see
page 11).
The grease we recommend is lithiumsa-
ponified hydroxide grease 12 with follo-
wing specifications:
Consistency:
Viscosity at
99°C (210°F)
Consistency stable
between
Dropping point
e.g.: WYNN'S MULTI PURPOSE GREASE
Order number 203 107
Service and repairs will be done in our
company.

7. Accessories

These are not supplied with the tool and
must be ordered separately
High-pressure grease gun
Order Number
NLGI Nr. 2
85 SSU
–17 and +180°C
(1.5 – 374°F)
+190°C (374°F)
203 005