Manufacturer's Warranty; Spare Parts Lists - REMS Secco 50 Notice D'utilisation

eng
5.4. Fault: The dehumidification performance diminishes.
Cause:
● Air filter (Fig. 6 (28)) or air filter mat/air filter flap (Fig. 3 (17)) dirty.
● Using the device reduces the humidity, this also reduces the amount of
condensation.
5.5. Fault: In the REMS Secco 80 error messages E1 or E3 are shown in the display (2).
Cause:
● The humidity of the room is outside the measuring range ≤ 30 % or ≥ 90 %
of the REMS Secco 80.
● Sensor for measuring the humidity is defective.
5.6. Fault: In the REMS Secco 80 error messages E2 or E5 are shown in the display (2).
Cause:
● Sensor for compressor temperature monitoring is defective.
5.7. Fault: In the REMS Secco 80, error message E4 is shown in the display (2).
Cause:
● 11.5 l condensation tank (9) (accessory, Art. No. 132100) is full.
● Condensation tank switch set incorrectly (5).
5.8. Fault: REMS Secco 50: Condensation tank LED (6) flashes.
Cause:
● Condensation tank (9) is full.
5.9. Fault: REMS Secco 50: Icing LED (18) flashes or lights steadily although the compressor is not iced up.
Cause:
● Device defective.
6. Disposal
REMS Secco 50 and R-410A or R-290 refrigerant, REMS Secco 80 and R-407C
or R-290 refrigerant, condensation tank with Secco 50 pump, condensation
tank with Secco 80 pump, operating hours counter and electricity meter including
batteries may not be thrown in the household waste at the end of their useful
lives. They must be disposed of properly by law.

7. Manufacturer's Warranty

The warranty period shall be 12 months from delivery of the new product to the
first user. The date of delivery shall be documented by the submission of the
original purchase documents, which must include the date of purchase and the
designation of the product. All functional defects occurring within the warranty
period, which are clearly the consequence of defects in production or materials,
will be remedied free of charge. The remedy of defects shall not extend or
renew the warranty period for the product. Damage attributable to natural wear
and tear, incorrect treatment or misuse, failure to observe the operational
instructions, unsuitable operating materials, excessive demand, use for unau-
thorized purposes, interventions by the customer or a third party or other
reasons, for which REMS is not responsible, shall be excluded from the warranty
Services under the warranty may only be provided by customer service stations
authorized for this purpose by REMS. Complaints will only be accepted if the
product is returned to a customer service station authorized by REMS without
prior interference and in a fully assembled condition. Replaced products and
parts shall become the property of REMS.
Remedy:
● Clean/replace parts, see 4.1. Maintenance
● Check whether the dehumidification/drying can be set.
Remedy:
● Set the device to continuous operation, see 3. Operation
● Have the device checked/repaired by an authorised REMS customer service
workshop.
Remedy:
● Have the device checked/repaired by an authorised REMS customer service
workshop.
Remedy:
● Empty the 11.5 l condensation tank.
● See 2.3. and 2.4.
Remedy:
● Empty the condensation tank.
Remedy:
● Have the device checked/repaired by an authorised
REMS customer service workshop.
The user shall be responsible for the cost of shipping and returning the product.
A list of the REMS-authorized customer service stations is available on the
Internet under www.rems.de. For countries which are not listed, the product
must be sent to the SERVICE-CENTER, Neue Rommelshauser Strasse 4,
71332 Waiblingen, Deutschland. The legal rights of the user, in particular the
right to make claims against the seller in case of defects as well as claims due
to wilful violation of obligations and claims under the product liability law are
not restricted by this warranty.
This warranty is subject to German law with the exclusion of the conflict of laws
rules of German International Private Law as well as with the exclusion of the
United Nations Convention on Contracts for the International Sales of Goods
(CISG). Warrantor of this world-wide valid manufacturer's warranty is REMS
GmbH & Co KG, Stuttgarter Str. 83, 71332 Waiblingen, Deutschland.

8. Spare parts lists

For spare parts lists, see www.rems.de → Downloads → Parts lists.
eng
15