Trouble Shooting Plan - Scheppach Structo 5.0 Traduction Du Manuel D'origine

Malfunction
1. Brake motor has no brake function
2. Saw blade detaches after switching
off the motor.
3. Motor does not initiate
4. Motor runs backwards or forwards
5. Motor does not perform, switches
off automatically
6. Burn marks on the intersection
by longitudinal cuts by cross cuts
7. Wrong rolling direction by rotary
current motor
14 english

Trouble shooting plan

Possible cause
a) Brake pads are worn
a) Attachment nuts are not tightened
enough
b) Brake effect of motor is too strong
a) Breakdown mains fuse
b) Extension cable defect
c) Connections to the motor or to the
switch are not in order
d) Motor or switch is defect
Condensator defect
Overcharged because of
a) Blunt saw blade
b) 2 Phase run – Motor becomes hot
a) Blunt saw blade
b) Wrong saw blade
c) Longitudinal end stop not parallel to
saw blade
d) Slide table not parallel to saw blade
Socket wrongly tapped
Solution
Have brake pads renewed.
Electrical connection works only by a
specialized electronics technician!
a) Tighten attachment nuts M20 left-
hand thread
b) Adjust electric current brakes
• Take out little plug sideways from
switch housing
• Use small screw driver to adjust
carefully the electric current of the
brakes on the potentiometer
• After switching off the motor the saw
blade stagnation should take place
after 8 - 19 seconds
• Put the little plug into the switch
housing again
a) Check mains fuse
b) See instructions "Electrical
connections"
c) Have it checked by an electronics
technician
d) See instructions "Electrical
connections"
Have it exchanged by an electronics
technician
a) Put in a sharpened saw blade
b) Have the extension cable and the
main power supply checked by a
specialized electronics technician
a) Put in a sharpened saw blade
b) Put in a saw blade for longitudinal
cuts
c) Re-adjust motor on rocker or
exchange longitudinal end stop
d) Align slide table to saw blade
Change polarity of socket