Scheppach Structo 5.0 Traduction Du Manuel D'origine page 15

with the adjustment handle.
• Place the wood into the recess and saw it carefully
exerting a uniform pressure.
• Switch off the machine and remove the wedges.
• Caution: Feed the work piece only with your hand on
the cross-cutting gauge. Do not hold the work piece
by hand.
Changing the sawblade, Fig. 12.1 and 12.2
Attention: Pull the power plug!
• Screw out the two upper bolts M 8 (1) from the lower
sawblade guard.
• Swing down the sawblade guard. Release the tension
nut (M 20, left-hand thread) and fix it with the holding
key (Fig. 12.2).
• Wear gloves to protect your hands.
• Remove the sawblade and fit a now one.
• Only mount a well sharpened, crack-free and not
deformed sawblade.
• Tighten the tension nut, fixing it with the holding key
(left-hand thread!).
• Raise the lower sawblade guard, re-insert the two bolts
M 8 and tighten them.
• After every sawblade change, the riving knife must be
adjusted anew - see Setting the riving knife Fig. 2.
Maintenance
Switch the motor off and pull the power plug before doing
any maintenance and cleaning work.
After servicing the machine, all guards and safety devices
must be refitted.
• The construction saw, including the electric motor,
are maintenance-free to a far extent. An exception are
the sawblades, table inserts and brake linings of the
electric motor (approx. 14,200 switching actions) that
are subject to natural wear and tear.
• The sawblade must stop within approx. ten seconds. If
necessary, the worn table insert must be replaced.
• Brake linings may only be replaced by specialists.
Cleaning
Attention: Pull the power plug!
Wear gloves (risk of cutting).
• Always wear goggles for cleaning to protect your eyes.
• Remove dust and dirt at regular intervals.
• Keep the protective sawblade box clean from scrap
wood and saw dust cloggings.
• For a good cleaning compressed air or a hand broom
are recommended.
• Keep the table surface free from resin.
• Caution: Do not use any cleaning agents on the plastic
parts. We recommend a mild rinsing agent on a moist
cloth.
english 13