Instructions For Use; Automatic Packing Functions - Zepter VacSy Manuel D'utilisation

6 - INSTRUCTIONS FOR USE

EN
1. When taking the machine out of its packaging check that all components are included and undamaged.
2. Read the User Manual before you use the machine for the first time.
3. VacSy® SEALING UNIT is a professional machine whose technology and capacity has been adjusted for use in households. Given its uses, the
machine is suitable for storage on the kitchen top where it can be used conveniently every day.
4. Place it on an even, smooth surface with enough space for placing food into bags.
6.1 AUTOMATIC VACUUM PACKING FUNCTIONS
Use the machine according to the following instructions:
1. Plug in the machine, switch it ON (pos. 1) and prepare Vacsy sealing unit for operation.
Check if the On / Off Indicator lights up (pos. 2).
WARNING! If the sealing unit has not been used for a long time (e.g. 1 week) perform a test-run of the appliance.
2. Lower the lid of the machine. Press on the rims of the lids (first one side, then other) until a click is heard (Figure 2).
Figure 2: Press on the rims of the lids (first
2 one side, then other) until a click is heard.
16
3. Press the Vacuum Packing of Bags but ton (pos. 4). Wait for the
Vacuum & Seal Indicator to stop blinking (pos. 7).
4. The Sealing Strip has warmed up and the machine is ready for
use. To lift the lid, press in the same place as you lock the machine
and with your fingers lightly push the round plate, which is on the
side of the machine (Figure 3).
Figure 3: First push with the wrist on the top
of the machine (at the same place as when
locking), and then press against the inside
round plate with the fingers, which is on the
3
side of the machine.
5. Make a bag from the roll as follows:
a.) Determine the length needed. A bag should be about 5 cm longer than the item to be vacuum packed. To reuse the bag, leave additional 2.5 cm
of bag material for each time you plan to reuse it, or next time use the bag for smaller items.
b.) Cut off the desired length with the included cutter (Figure 4).
c.) Place the roll on the Sealing Strip and extend it to the Black Gasket (Figure 5). Make sure that the edge is straight and level.
ATTENTION! Pay attention how the roll is placed when sealing function is in use.
d.) Lower the lid of the machine. Press on the rims of the lid (first one side, then the other) until a click is heard.
e.) Press the Seal button (pos. 3). During sealing, the light (Vacuum & Seal Indicator) will be blinking.
Figure 4: Determinate
the needed length
and cut it off with the
manual cutter.
4
RECOMMENDATION: If the machine does not start with the sealing process right after you press the Seal button, then press gently on the middle
of the lid with your finger.
f.) When the indicator is no longer blinking, lift the lid. Press in the same place as you do to lock the machine and lightly push the round plate
on the side of the machine with your fingers (Figure 3). Check the sealing edge on the bag. It should be smooth and even across its width
and not creased.
Figure 5: Place the roll
on the Sealing strip and
extend it to the black
gasket to seal.
Make sure to straighten
and even the roll edge.
5
EN
17