Programming; Filter; Filter Use - Rotel Aromatica DIGITAL 271 Mode D'emploi

4. Programming

☛
It is possible to reprogram the following settings:
Filter / Water hardness / Temperature / Language / Time (Standby time on or off)

4.1 Filter

Filter use

You receive a special filter as an accessory for the water tank of this coffee machine.
By using the filter correctly, it is no longer necessary to de-calcify your coffee machine.
The filter setting must be set to YES so that the machine recognizes that the filter is in
use. The factory setting is without a filter.
☛
If you use a filter in your coffee machine and have programmed the system fil-
ter setting to YES, programming for water hardness and decalcifying will not be
shown anymore.
• Press the programming button P in order to start program mode.
• Press the > button until the display shows FILTER.
• Press the ok button.
• Press the > button until the display shows YES.
• Confirm with the ok button.
• The display will now show CHANGE FILTER / TURN valve alternatingly.
• Empty the water tank (17) screw the filter into the holder (21) using the mounting
tool (24).
• Fill the tank with freshwater and replace it in the machine.
• Hold a receptacle under the hot water jet (12) and turn the dial (11) to the right. The
system will now be rinsed.
• Wait until no more water comes out of the jet and then turn the dial (11) closed to
the left.
• The system will heat up briefly and is then ready for operation again.
(It can happen that the service button [7] is still blinking. Press the button [7] and a
short rinse will take place through the coffee outlet [8].)
☛
The effectiveness of the filter is exhausted after about 50 l of water. The display
will indicate that the filter must be changed (see chapter 5.2).
Important: Even if the display shows nothing, the filter should be changed after
two months at the latest even if little coffee was brewed.
28
The following function buttons under the display (1) are
used for programming:
P Program mode
Selection button
>
ok Confirmation button
exit Stop or exit the programming