Manual Decalcifying - Rotel Aromatica DIGITAL 271 Mode D'emploi

Caution: – You may not interrupt the decalcifying program.
– Never use vinegar or acidic liquids for decalcifying your coffee machine;
• Press the service button (7) ca. 2 sec. The display shows EMPTY trays.
• Empty the drip pan (9b) and slide it back in. The display shows DECALC IN TANK.
• Remove the water tank (17).
• Fill it with decalcifying liquid along with the correct amount of water (follow the
manufacturer's instructions) to fill it ONLY to the 0.5 l mark.
• Replace the tank. The display shows TURN valve.
TIP: Place a sufficiently large receptacle (ca. 0.5 l) under the steam/hot water jet (12).
• Open the steam/hot water dial (11) by turning clockwise.
• The coffee machine will automatically decalcify and the solution will flow through
the hot water jet (12) at intervals (ca. 10 min.).
• Wait until the next message appears in the display: TURN valve.
• Close the dial (11) again by turning it counterclockwise.
• The decalcifying solution will now flow through the inner outlet in intervals (ca. 15 min.).
• Wait until the next message appears in the display: EMPTY trays.
• Empty the drip pan (9b). The display shows FILL WATER.
• Fill the water tank (17) with fresh water. The display shows TURN Valve.
• Open the dial (11) by turning it clockwise.
• The system will be rinsed again through the steam/hot water jet (12) in intervals (ca.
5 min.). The display shows TURN Valve.
• Close the dial (11) again by turning it counterclockwise.
• The system is rinsed through the inner outlet in intervals (ca. 5 min.). The display
shows EMPTY trays.
• Empty the drip pan (9b) and reinsert it. The system will heat up briefly. The display
shows PLEASE RINSE and the service button (7) blinks.
• Press the service button (7) and the system will be rinsed through the coffee out-
let (8).
• Your coffee machine is ready for operation again.

Manual decalcifying

If you want, you may start the decalcifying program without a prior alarm showing:
• Press the programming button P in order to start program mode.
• Press the > button until the display shows DECALC.
• Press the ok button. The display shows Man.decalc.
• Press the ok button. The display shows EMPTY trays.
• Continue as above for «Empty the drip pan (9b)...».
☛
If you start the manual decalcifying program by accident, you may interrupt it
by pressing the on/off button (2) for a few seconds.
34
only use Durgol or a similar product.