Drawing Hot Water; Drawing Steam; Foaming Milk - Rotel Aromatica DIGITAL 271 Mode D'emploi

3.6 Drawing hot water

• Place your cup under the jet (12).
• Turn the steam/hot water dial (11) to the right.
• Fill your cup with the desired amount of water and turn the dial (11) back to 0.
☛
Caution: Very hot water and danger of burns! The water from the jet can
spray around. Touch only the black plastic part of the jet.

3.7 Drawing steam

• Place the cup with the liquid to be warmed up under the black swivel jet (12).
• Press the steam preheating button (10).
• As soon as the system is ready, STEAM is READY and TURN valve appear in the
display.
• Turn the steam/hot water dial (11) to the right. Please note: Water will first come out
and then steam.
• By turning back the dial (11) to 0, the process is stopped.
• Press the steam preheating button (10) and the coffee machine will be reset for nor-
mal operation.
☛
You can make steam for up to two minutes. The machine will then turn off
automatically. By turning the knob (11) back and forth, you can continue the
process.
☛
Caution: Very hot steam and danger of burns! Only touch the jet on the black
plastic part!

3.8 Foaming milk

Using the special foaming tool (see page 5), you can foam fresh milk directly in your
cup.
• Mount the foaming tool as shown in the illustration on page 5.
• Inserts the hose (12c) into the receptacle with milk and place the cup under the
steam/hot water jet (12).
• Press the steam preheating button (10).
• When the system is ready (see section 3.7), turn the steam/hot water dial (11) slow-
ly to the right.
• You can open the twist valve (12b) as soon as steam comes out of the steam jet (12).
• The milk is soaked up and fed into the cup as foam.
• End this process by closing the twist valve (12b) and the dial (11) again.
☛
Dried residue on the foaming tool and jet is difficult to remove. You should
therefore clean it immediately after it has cooled off.
27