Wilo Veroline IP-E Notice De Montage Et De Mise En Service page 47

ENGLISH
14
15
The display returns to the basic setting
In the event of a fault, the fault menu
PLR/LON active
16
42
LC display
Sending LON service signal
Note:
X
This menu is only displayed if IF module LON is plugged in!
14
Press button to display the next menu (
Switching function on/off:
Turn the tuning button. The new setting blinks.
Press button to store the new setting.
X X
Menu or is displayed.
2
15
If the condition "on" is confirmed, a single service signal is sent to the
building management system.
MA / SL setting
Note:
X
This menu is only displayed in double pump mode!
15
Programming is only possible on the MA pump.No settings can be made
on the SL. Changing the master - slave allocation is only possible on the
master.
The current setting is displayed.
If the master - slave allocation was wrongly selected when starting up for
the first time (recommendation: master in flow direction on left with
connected pressure sensor, slave in flow direction on right (see Fig. 1a)),
the setting can be corrected in this menu.
Changing MA / SL setting:
Turn the tuning button. The new setting blinks.
Press button to store the new setting.
X
.
2
X
is displayed instead of the basic setting
2
Automatically activated with plugged in LON module and signal from the
external building automation system.
A symbol in the form of a double arrow appears in the display:
The following settings are possible:
Operation menu > Addition or main/reserve mode
Service menu > Display orientation, IN1 selection, error matrix, LON-
ID (only with LON module), change MA/SL, dPS on/off
Setting
X X
or ).
2
15
X
.
18