Wilo Veroline IP-E Notice De Montage Et De Mise En Service page 46

12
13
LCdisplay
Setting the range of values for the set pressure value (step 3)
This menu comes after the above menu
The setting – V or mA – is taken from the previous step.
The upper limit of the range of values is 10 V or 20 mA.
The value for the lower limit blinks.
Setting the lower limit
[0 (-10V) / 2 (-10V) or 0 (-20 mA) / 4 (-20mA)]:
Turn the tuning button. The new setting blinks.
Press button to store the new setting.
X
Menu is displayed.
13
Activating / deactivating the fault-tolerant error matrix
Switching between heating / air-conditioning mode
Setting the mode
Turn the tuning button. The new setting blinks.
Press button to store the new setting.
X X X
Menu , or is displayed..
2
14 15
The mode selection determines the reaction in the case of a fault condi-
tion.
ENGLISH
Setting
X
.
11
41