Service Menu - Wilo Veroline IP-E Notice De Montage Et De Mise En Service

ENGLISH
Double pump mode: Menu order during standard use:
After switching on the module, all symbols
MA display the same menu sequence
5
The display returns to the basic setting
In the event of a fault, the fault menu

7.4.3 Service menu

The service menu is used for all settings other than the standard settings.
Pressing the "red button" for more than 6 seconds activates the service menu.
> 6 sec
The displays can be scrolled in sequence (see annex). At the end of the sequence the status display re-appears.
After 30 seconds without any input the status display also re-appears and all temporary, unacknowledged changes
are rejected.
6
38
X
. appear on the display for 2 s. Next, the current setting
1
X X
2 ... 4 appears as with the single pump. Next, menu
LC-display
LC display
Setting addition or main/reserve mode
The current setting blinks.
Setting the mode:
Turn the tuning button. The new setting blinks.
Press button to store the new setting.
X
.
2
X
is displayed instead of the basic setting
18
Display orientation
The display shows the current display orientation "Lcd" (factory setting =
shaft in horizontal position):
Setting the display orientation
Turn the tuning button. The new setting blinks.
Press button to store the new setting.
X
is set. When "scrolling" in the
2
X
5 appears.
Setting
X
2 .
Setting